As I mentioned, it was a stupid oversight on my part but thanks for the tip. 👍 

ps wwwp <list of pids>

This will show the full command line, including all options, of the running processes

Thanks for your post, it was a stupid error on my part. I did say this was a 'clean install' but I completely forgot that I did my usual routine of installing webmin as well and... it uses port 10000. When it first got the 'error' of port 10000 I looked and all I found were two running perl modules so I thought this might have been a carbonio module as it uses a lot of perl and totally forgot about webmin.

Now time to see how Carbonio works. :)

zmcontrol stop

netstat -putan | grep 10000

When I start Carbonio it gives the following error:

Starting proxy...Failed.
Starting proxy...nginx:  bind() to 127.78.0.21:10000 failed (98: Address already in use)
nginx:  bind() to 127.78.0.21:10000 failed (98: Address already in use)
nginx:  bind() to 127.78.0.21:10000 failed (98: Address already in use)
nginx:  bind() to 127.78.0.21:10000 failed (98: Address already in use)
nginx:  bind() to 127.78.0.21:10000 failed (98: Address already in use)
nginx:  still could not bind()
failed.

I can't seem to find what is causing it to give that error, can anyone point me in the right direction?

Regards

Bill